Ohm's law tells you what a resistor does. The resistance formula tells you why a particular piece of wire is a resistor of that size in the first place. Whenever a question gives you a wire and asks for its resistance, you are using R = ρL/A, and almost every twist the examiners add is a change to one of these three letters.

Longer or thinner wire: more collisions, slower drift, higher R

The formula and what each part means

R = ρ L / A

Longer wire, more resistance: electrons collide with more lattice ions on the way through. Thicker wire, less resistance: more parallel paths. And ρ (resistivity) is a property of the material, measured in ohm-metres. Resistance depends on the shape of the sample, but resistivity does not. Copper has ρ ≈ 1.68×10⁻⁸ Ω·m at 20 °C, aluminium about 2.8×10⁻⁸ Ω·m, and nichrome, used in heaters, about 1.1×10⁻⁶ Ω·m, roughly 65 times more than copper.

Worked check: a 10 m copper wire of cross-section 1 mm² (10⁻⁶ m²): R = 1.68×10⁻⁸ × 10 / 10⁻⁶ = 0.168 Ω. A heater coil of nichrome, 1 m long and 0.5 mm in diameter (A = π × (0.25×10⁻³)² ≈ 1.96×10⁻⁷ m²): R = 1.1×10⁻⁶ × 1 / 1.96×10⁻⁷ ≈ 5.6 Ω. A short piece of thin nichrome beats ten metres of copper wire by a factor of 33, which is exactly why heaters use it.

The stretching-wire question

This one appears again and again. A wire is stretched to twice its length. Volume cannot change, so the area halves. Now L doubles and A halves, so R becomes 2 × 2 = 4 times the original. In general, if length changes by a factor n, resistance changes by n². The same trick works for a wire drawn through a die, a spring uncoiled or a rubber tube squeezed. Always ask: what stays constant? Volume does, and that links L and A.

Temperature

R = R₀ [1 + α (T − T₀)]

For metals α is positive, about 0.0039 per °C for copper, so a copper coil heated from 20 °C to 60 °C has resistance 1 + 0.0039 × 40 ≈ 1.16 times larger. The explanation: hotter ions vibrate harder and scatter electrons more. Semiconductors like silicon and germanium go the other way. Heating frees more charge carriers, so resistance falls, and α is negative. That difference is why thermistors are made from semiconductors and why a metal-filament bulb behaves oddly at switch-on.

The bulb that draws a surge

A tungsten filament at room temperature has a resistance many times smaller than at its glowing temperature, roughly ten to fifteen times lower for an incandescent bulb. At the moment of switching on, current is much higher than the steady value, which is why old bulbs usually fail just when you flip the switch. The graph of V against I for such a bulb bends away from a straight line, so the bulb is not an ohmic conductor even though the wire is made of metal.

One small modern note: since the 2019 revision of the SI, the ohm is defined through fixed values of h and e, not through a physical artefact. Nothing changes for school problems, but it shows how resistance standards are now tied to nature, not objects.

Try it yourself

Resistivity Factors Ohm's Law V-I Curve Series & Parallel Circuits