Home / Mechanics / Viscosity & Stokes' Law

Viscosity & Stokes' Law

JEEWBJEE
Current speed: 0 mm/s Terminal velocity: 0 mm/s —

The physics

A sphere falling through a viscous fluid speeds up until the upward viscous drag (proportional to its speed) exactly balances gravity minus buoyancy — beyond that point, it falls at a constant terminal velocity.

Stokes' law (viscous drag): F = 6πηrv
Terminal velocity: v_t = 2r²(ρ_ball − ρ_fluid)g / (9η)
At terminal velocity: weight = buoyant force + viscous drag

This simulation integrates the actual equation of motion (net force = weight − buoyancy − drag, divided by mass) rather than jumping straight to the terminal velocity formula, so you can watch the approach to terminal speed happen gradually, exactly as it does in a real viscosity experiment.

Exam tip: terminal velocity scales with r² — a common JEE trap gives two balls of different radii falling in the same fluid and asks for the ratio of terminal velocities, which is simply (r₁/r₂)², not r₁/r₂.

Sample data: terminal velocity of steel balls falling in viscous liquids

v_t = 2r²(ρ_ball − ρ_fluid)g/(9η) for a steel ball of density 7800 kg/m³. The last column is the Reynolds number Re = ρvd/η, which should be below about 1 for Stokes' law to hold.

LiquidViscosity ηBall radiusTerminal velocityReynolds number
Glycerin1.49 Pa·s0.5 mm0.24 cm/s0.002
Glycerin1.49 Pa·s1 mm0.96 cm/s0.016
Glycerin1.49 Pa·s2 mm3.82 cm/s0.129
Castor oil0.985 Pa·s1 mm1.51 cm/s0.029
Engine oil0.29 Pa·s1 mm5.20 cm/s0.315

Conditions: viscosities at about 20 °C, steel ball in an unbounded liquid, g = 9.8 m/s².

Notice: doubling the radius from 1 mm to 2 mm in glycerin makes the ball fall 4 times faster, since v_t varies as r². The thinner the liquid, the faster the fall: in engine oil the ball is about 5 times faster than in glycerin. The table is limited to small balls and thick liquids, because in water Re would be far above 1 and Stokes' law would fail.

🎯 Practice Zone

Puzzle 1. ⚖️ A ball dropped into a viscous fluid eventually reaches a constant "terminal" velocity rather than continuing to accelerate forever under gravity. Why does it stop accelerating?

As the ball speeds up, viscous drag (which increases with speed, F=6πηrv) grows larger and larger, while the net driving force (weight minus buoyancy) stays constant. Eventually drag grows large enough to exactly balance the constant driving force — at that exact speed, net force becomes zero, and by Newton's first law, the ball then moves at that constant "terminal" velocity indefinitely, no longer accelerating at all.

Puzzle 2. 📏 Terminal velocity scales with the SQUARE of the ball's radius (v∝r²), not simply proportional to radius. Why does doubling the radius quadruple the terminal velocity rather than just doubling it?

Two competing effects both scale with radius, but at different rates. The net driving force (weight minus buoyancy) depends on the ball's VOLUME, which scales as r³. The drag force's radius-dependence (from Stokes' law, F=6πηrv) is only linear in r. When you solve for the terminal velocity where these balance, the r³ (driving force) divided by the r (drag's radius factor) leaves a net r² dependence in the resulting terminal velocity — a genuinely non-obvious result that comes directly from this asymmetric scaling.

Puzzle 3. 🍯 Why does the same steel ball fall much slower (reach lower terminal velocity) in honey than in water, even though both are liquids and the ball's weight and buoyancy barely differ between them?

Terminal velocity is inversely proportional to viscosity (v∝1/η) — honey's viscosity is roughly 1000-10,000 times greater than water's, directly producing a proportionally much smaller terminal velocity for the exact same ball. The driving force (weight minus buoyancy) is nearly identical in both fluids since their densities are fairly similar, but the dramatically higher viscous resistance in honey requires the ball to reach only a much lower speed before drag force can balance that driving force.

Puzzle 4. 🌡️ A liquid's viscosity typically decreases significantly as temperature increases (this is why honey pours much more easily when warmed). How would warming the fluid affect a falling ball's terminal velocity in this same experiment?

Terminal velocity would increase, since v∝1/η and warming reduces η. This is a genuinely important real-world consideration in viscosity-measurement experiments — precise temperature control is essential, because even a small unintended temperature change during the experiment can noticeably shift the measured terminal velocity and throw off the calculated viscosity value if not carefully accounted for.

Puzzle 5. 🌧️ Raindrops falling from clouds reach a terminal velocity determined by air's viscosity and drag, rather than accelerating all the way to the ground at increasing speed. Why is this terminal-velocity effect fortunate for us, rather than dangerous?

Without any terminal velocity limit, a raindrop falling from a cloud several kilometers up would continue accelerating under gravity the entire way down, striking the ground (and anyone standing in it) at genuinely dangerous, injury-causing speeds. Air resistance and viscous drag effects cap raindrops' terminal velocity at a modest, harmless few metres per second — precisely why rain, even from very high clouds, falls gently rather than as a hazardous bombardment. (Real raindrop terminal velocity involves more complex, higher-Reynolds-number drag physics than the simple Stokes' law shown here, but the fundamental "drag caps the speed" principle is exactly the same.)

Problem 1 (NEET level). 📘 Find the terminal velocity of a steel ball (ρ=7800 kg/m³, r=5mm) falling in glycerin (ρ=1260 kg/m³, η=1.5 Pa·s).

v_t = 2r²(ρ_ball−ρ_fluid)g/(9η) = 2(0.005)²(7800−1260)(9.8)/(9×1.5)
v_t = 0.2374 m/s

Problem 2 (JEE Main level). 📗 Verify that at this terminal velocity, drag force exactly equals the net downward force (weight minus buoyancy).

Drag: F_drag = 6πηrv_t = 6π(1.5)(0.005)(0.2374) = 0.03356 N
Net weight: F_net = (4/3)πr³(ρ_ball−ρ_fluid)g = 0.03356 N
Exact match ✓ — confirming the force-balance condition that defines terminal velocity

Problem 3 (WBJEE level). 📙 A second steel ball, with double the radius (r=10mm), falls in the same glycerin. Find its terminal velocity, and verify the r² scaling.

v_t(10mm) = 2(0.01)²(6540)(9.8)/(9×1.5) = 0.9495 m/s
Ratio: v_t(10mm)/v_t(5mm) = 0.9495/0.2374 = 4.0 — exactly (2)² as predicted, confirming the r² scaling from the exam tip

Problem 4 (CBSE Class 11 level). 📕 A steel ball (r=3mm) falls through an unknown oil (ρ=900 kg/m³) with measured terminal velocity 0.05 m/s. Find the oil's viscosity.

η = 2r²(ρ_ball−ρ_fluid)g/(9v_t) = 2(0.003)²(7800−900)(9.8)/(9×0.05)
η = 2.70 Pa·s (this reverse-engineering approach — measuring terminal velocity to find viscosity — is exactly how real Stokes' law viscometers work)

Problem 5 (JEE Advanced style). 📓 For Problem 1's scenario, estimate the Reynolds number (Re=ρ_fluid×v×d/η, where d is diameter) to check whether Stokes' law is actually valid (ideally Re≪1).

Re = ρ_fluid × v_t × d/η = (1260)(0.2374)(0.01)/1.5
Re = 1.99
This is not comfortably ≪1 — meaning Stokes' law is only an approximate description here, with some deviation expected in a real experiment. This is a genuinely important caveat: real experimenters must choose small enough balls and/or high enough fluid viscosity to keep Re safely below 1 for Stokes' law to apply accurately.
🌊
1845

George Gabriel Stokes derives the exact drag force formula for a sphere moving slowly through a viscous fluid — a landmark result in fluid dynamics, obtained by directly solving the Navier-Stokes equations for this specific, highly symmetric case.

⚡
1909–1913

Robert Millikan famously applies Stokes' law in his oil-drop experiment, precisely measuring the terminal velocity of tiny charged oil droplets falling (and rising, under an applied electric field) to determine the fundamental charge of the electron — a direct, historically pivotal application of exactly this formula.

🏆
1923

Millikan wins the Nobel Prize in Physics largely for this oil-drop work — Stokes' law, originally a pure fluid-dynamics result, turns out to be essential to one of the foundational measurements in atomic and particle physics.

🔬
20th century

Falling-ball viscometers based directly on Stokes' law become standard laboratory instruments for measuring fluid viscosity across chemistry, materials science, and industrial quality control, valued for their conceptual simplicity and direct connection to fundamental physics.

🩸
Present day

Stokes' law and its extensions remain essential in biomedical and environmental engineering — modeling the settling of blood cells in centrifuges, the fall of dust and pollutant particles through air, and the sedimentation of particles in water treatment processes.