Two torches shone on the same wall just make it brighter. Two light waves that are properly prepared can make part of the wall darker than either alone. That strange result is interference, and it is the most direct evidence that light is a wave.

Two waves add up: the intensity swings between 0 and 4I₀ as the phase changes

Coherent sources

Interference needs two sources that are coherent: they must have the same frequency and a constant phase difference. Two separate bulbs are not coherent, because their phases change randomly billions of times a second. In practice we split one source into two, as in Young's double slit experiment.

Conditions for bright and dark

At a point where two waves meet, the path difference Δ decides the result:

Constructive (bright): Δ = nλ,   φ = 2nπ
Destructive (dark): Δ = (n + ½)λ,   φ = (2n + 1)π
Phase difference: φ = (2π/λ) × Δ
Check: for λ = 500 nm and Δ = 1.5 μm, Δ/λ = 3, a whole number, so the point is bright. For λ = 600 nm and Δ = 0.9 μm, Δ/λ = 1.5, so it is dark.

Resultant intensity

Intensity is proportional to the square of the amplitude, so for two waves with intensities I₁ and I₂ and phase difference φ:

I = I₁ + I₂ + 2√(I₁I₂) cosφ

For equal intensities I₀, this becomes I = 4I₀cos²(φ/2). The maximum is 4I₀, four times a single source, and not two. The minimum is zero. Energy is not lost: the dark places lose exactly what the bright places gain, so the average is 2I₀.

Ratio of maximum to minimum intensity

I_max / I_min = (a₁ + a₂)² / (a₁ − a₂)²
Example: two sources with an intensity ratio of 9 : 1 have an amplitude ratio of 3 : 1. I_max/I_min = (3 + 1)² / (3 − 1)² = 16/4 = 4. Unequal sources give poor contrast, which is why the slits in a double-slit experiment are made equal.

Fringe width

In YDSE, the width of one bright fringe is β = λD/d, with d the slit separation and D the screen distance. Red light (longer wavelength) gives wider fringes than blue light, and a smaller d also widens the pattern.

Interference also shows up in thin films, such as soap bubbles and oil on water, which we cover in our note on the double slit and in the Newton's rings simulation.

More solved problems

Problem 1: Fringe width in YDSE
In a Young's experiment, d = 0.5 mm, D = 1 m and λ = 600 nm. The fringe width is β = λD/d = 6 × 10⁻⁷ × 1 / 5 × 10⁻⁴ = 1.2 mm. The third bright fringe is 3β = 3.6 mm from the centre, the first dark fringe is at β/2 = 0.6 mm and the second dark fringe at 1.5β = 1.8 mm.
Problem 2: Intensity at an intermediate point
Two identical waves of intensity I₀ meet with a phase difference of 60°. I = 4I₀cos²(φ/2) = 4I₀cos²30° = 4I₀ × 0.75 = 3I₀.
Problem 3: The whole setup in water
If the YDSE of Problem 1 is immersed in water (n = 1.33), the wavelength shrinks to λ/n, so the fringe width becomes 1.2 / 1.33 ≈ 0.90 mm. The pattern is squeezed, but its shape is unchanged.
Problem 4: A soap film
A soap film (n = 1.33) is lit by light of λ = 560 nm falling normally. The thinnest film that gives a bright reflection satisfies 2nt = λ/2 (one reflection gives an extra half-wave shift), so t = λ/4n = 560 / (4 × 1.33) ≈ 105 nm.

Practice questions (with answers)

  1. Two sources are coherent if they have
    (a) the same amplitude   (b) the same frequency and a constant phase difference   (c) the same colour only   (d) the same intensity
  2. For the second dark fringe, the path difference is
    (a) λ   (b) 3λ/2   (c) 2λ   (d) 5λ/2
  3. If the amplitudes of two waves are in the ratio 2 : 1, then I_max / I_min is
    (a) 3   (b) 4   (c) 9   (d) 2
  4. If the slit separation is doubled, the fringe width
    (a) doubles   (b) halves   (c) stays the same   (d) becomes 4 times
  5. With white light in YDSE, the central fringe is
    (a) red   (b) violet   (c) white   (d) dark
Show answers
  1. (b) the same frequency and a constant phase difference.
  2. (b) 3λ/2. The dark fringes are at (n + ½)λ, so n = 1 gives 3λ/2.
  3. (c) 9. (2 + 1)² / (2 − 1)² = 9.
  4. (b) halves, since β = λD/d.
  5. (c) white. All colours have zero path difference there, so all are bright. Coloured fringes appear on either side.

Common doubts

Why do two bulbs not give interference?

Each bulb emits light as many short bursts with random phases. The phase difference between two bulbs changes billions of times a second, so the pattern shifts too fast for any eye or detector to follow, and the average is uniform.

Is energy lost in the dark fringes?

No. Energy is redistributed. The average intensity over the pattern is exactly the sum of the two separate intensities, but it is moved from the dark places to the bright ones.

Why does a soap bubble show colours?

Light reflects from the front and the back of the thin film, and the two reflections interfere. The thickness is a fraction of a micrometre, so the condition for brightness is met by different colours at different thicknesses.

Try it yourself

YDSE Newton's Rings & Thin Films Diffraction & Polarization